#200 amp disconnect box install

If supervision is the problem your wire would need to be rated for 200a even if it is going into a smaller panel or that’s what is normally required in my jurisdiction or one county. Although allowed by 240.21.5 with the tap made at the breaker. The problem is many inspectors won’t allow use of the tap rules because of the length of the run and not supervised. You can tap that at the protected side of the breaker. Or would I Need to put a 60 amp disconnect next to the 200 amp box and run to the garage? So, do the outside tap rules allow me to tap the load side of the 200 amp breaker and run it to a 60 amp main at the garage? The disconnect would be at the garage. It would be difficult to run from the house load center, as it is in the middle of the house. adjacent disconnect 200 amp to the right. Here is a picture of the meter and adjacent 200 amp disconnect. Also, do I need a ground rod at the garage? Thank you in advance for your responses and any enlightenment you may choose to shower on me.

#200 amp disconnect box install

I would also install a backfed 60 amp breaker in the sub panel (or an AC disconnect) so I could disconnect everything there (normal AC disconnect does not provide over current protection).Ĭan I tap this way, or, what is the correct way to do it and what size wire should I use for the 60 ft underground run (direct bury cable, THHW or similar in conduit, or something else)? and what size Polaris lug to use (what size wire is used for 200 amp from the breaker to the inside the house). The new feeder line would be protected by the 200 amp breaker which would be immediately upline of the Polaris lug. The NEC on taps and feeders is somewhat confusing but looking at the section on outside feeder taps, it appears I should be able to do this without adding another disconnect at the house.

can tap the load side of the 200 amp breaker using Polaris lugs and putting a disconnect on this feeder line immediately adjacent to the existing one.

can't tap at the service box outside the house.

The sub in the garage is located adjacent to the pull up garage door. However, I think 60 amps would be more than adequate for my needs (1 20amp with 5 boxes, 1 20 amp dedicated to 10,000 BTU window Air conditioner, 1 15 amp circuit for 3 lights, 1 future 20 amp circuit to run to shed, 1 future 30 amp 240 volt circuit just in case) The total length of the run from the main service disconnect outside the house (200 amp) to the sub in the garage is about 60 ft. I have a QO load center QOB8-16L 100S which is rated for 100 amps.

I have a newly built garage that I would like to add a sub panel.